large 7 segment display clock showing 9:53 time

Clock Part 3

I finally finished the outer case of my clock. Only 19 layers of 3mm acrylic stacked on top of each other.

IMG_5445
Laser cutting the rear panel and finger slot
red perspex box with clock electronics showing, rear lid off
Rear panel with finger slot and barrel jack holder
rear panel of clock with wire going into the finger slot
Barrel Jack inside the finger slot

I built a finger slot into the back of the clock so it’s easier to carry, but also to house the barrel jack for mounting the clock flush to the wall, allowong me to hide the power cord in the wall (oneday)

pile of acrylic sheets neetly lined up
This is the pile of acrylic I had to cut out of the inside of the clock.

That pile on the left was cut out to make the cavity in the case.


Posted

in

,

by

Tags:

Comments

Leave a Reply

Your email address will not be published. Required fields are marked *